Ku nst sto ffschweißtec hni k
Starting and operating
Chapter 5
27.10.2011
Working Instructions WIDOS 6100 CNC 3.0
Page 31 of 76
Display:
2
nd
line:
insert planer
start planer
Noises exceeding 80 dB (A) may occur; during planing it is obligatory to wear ear
protection!
Suspend the planer into the basic machine, keep button <Planer> pressed
until
a circular chip running 2-3 times around the pipe ends is
formed
and the pipe ends are plane (The switch-from the planer has to be
switched on)
Display:
2
nd
line:
planer working
Ps=000 Pi=000 P
0
=0.0
During the planing process, the desired, actual and
drag pressures are displayed
after a few seconds, the display changes
Display:
2
nd
line:
alignment check
start planer
Unlock the planer and take planer out of the
machine, remove chips, do not touch the surfaces.
button <Start>: alignment check is started
Display:
2
nd
line:
closing machine
Sledge closes
after a few seconds, the display changes
Display:
2
nd
line:
confirm alignment
test pressure
Keep pressed button <+> to check the pressure
build-up (e.g. whether pipes slip through)
If the alignment of the pipes is correct, confirm with button <Start>.
The misalignment may not be higher than 10 % of the wall thickness.
If the misalignment is too high, re-adjust the pipe ends in the basic clamping
devices and repeat the planing process.
Display:
2
nd
line:
opening machine
after a few seconds, the display changes
