BlueGate 2100
Installation
July 26, 2001
WIDCOMM, Inc, Proprietary and Confidential
4
3.2 W
ALL OR
C
EILING
I
NSTALLATION
Required materials and tools:
•
Adhesive tape.
•
#2 Philips head screwdriver or drill/driver with Philips bit.
Install template and drywall anchors:
NOTE:
The self-drilling anchors are for drywall
installation only. The anchors are not
recommended for use in acoustical ceiling
tiles or other types of wall / ceiling materials.
1. Decide where BlueGate 2100 will be mounted keeping in mind:
The lengths of the Ethernet cable and power cord.
The location of the Bluetooth-enabled devices that will use BlueGate 2100’s
service. Typically devices must be within 30 meters of BlueGate 2100; walls
and other obstructions may shorten this distance.
2. Tape the mounting template to the installation location and use a nail or other
small pointed object to mark the locations of the screw anchors.
3. Remove the template.
4. Using a screwdriver or drill/driver, install the self-drilling drywall anchors:
a) Place the screwdriver or driver/drill into recess of anchor.
b) Press the anchor into the drywall while turning the anchor clockwise until it
is seated flush with the wall.
Mount BlueGate 2100:
1. Slide the covers outward from the center of BlueGate 2100 to remove them.
NOTE:
Do not lift or pry the covers.
2. Complete the power cord and Ethernet cable installation described in Section 3.1
(also described in the
Start Here
booklet).
3. Hold the base of BlueGate 2100 firmly against the wall or ceiling aligning the
device’s screw holes over the wall anchors.
4. Using the four (4) included Philips head screws, secure BlueGate 2100 to the
wall anchors.
5. Replace the covers.