7
Schematic Installation - Incorrect
Isolating valves
missing
Other cold
draw offs
Cold
supply
Hot
supply
D.H.W.
60
o
C
Vent
pipe
Cistern
Avoid high-level hot
feed pipe runs
(may cause air
locking)
Hose retaining
ring missing
(see Water Byelaws)
Strained hose
*
*
*
*
Other hot draw
offs
Side
entry
boss
* Incorrect supply
connections
1.
Do not
install in a position where the unit can become frozen.
2.
The shower unit
must
be supplied from a cold storage tank and
hot water cylinder with equal pressures. The shower unit
must
not
be connected to a Mains Cold water supply, Unvented High
Pressure systems or Multi-Point/Combination Gas Water
Heaters.
3.
Ensure that HOT (H) and COLD (C) supplies are connected to
the correct inlets. These are clearly marked. Failure to do so
could be dangerous.
4.
The shower unit is for surface mounting only and
must not
be
recessed into any wall or cavity, or tiled up to, as this will inhibit
water drainage from rear of unit.
INSTALLATION
General
