RF Exposure to radio frequency radiation
■
To comply with
FCC
RF exposure compliance requirements, a separation distance of at least 20 cm
must be maintained between the antenna of this device and all persons.
This device must not be co-located or operating in conjunction with any other antenna or transmitter
Marketting of the place
■
This product which can be placed on the market and be put into service EU except for some contry (FR,BYL,ROU)
Information to the User
■
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
EU restriction statement
European standards dictate maximum radiated transmit power of 100mW EIRP and frequency range 2.400-2.4835GHz.
France - 2.4GHz for Metropolitan France :
In all Metropolitan départements, wireless LAN frequencies can be used under the following conditions,
either for public or private use:
- Indoor use: maximum power (EIRP*) of 100 mW for the entire 2400-2483.5 MHz frequency band
- Outdoor use: maximum power (EIRP*) of 100 mW for the 2400-2454 MHz band and with maximum power (EIRP*)
of 10 mW for the 2454-2483 MHz band
Label declaration
■
the label will be visible at the time of purchase and before the first use
( the battery must be installed before the first use.)
……………………………………………………………………………………………………………………
*
CAUTION :
■
Changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate the equipment.
■
UMPC device is designed for hand-held operation only
……………………………………………………………………………………………………………………
Illumination
■
Do not use the product in dark locations.
The illumination level for product use must be as bright so for reading a book.
■
Indirect illumination is recommended. Use a curtain to prevent reflection on the LCD screen.
Operation Condition
■
Do not use the product in hot and humid locations.
■
Use the product within the allowed temperature and humidity range specified in the User Guide.
10