13
12
Exit
Knob
Function
Adjust
Select
Current
A
0
9
ON
VRD
DC Stick
RED indicates Selected
Weld Parameter
Weld Current
Arc Force
Recommended
Electrode Size
Parameter
Setting
Use Left
button to
select Exit
Rotate knob to
move to next
Parameter
Press knob
to accept
Parameter
Use Left button to
select Function
Machine
Function
Status
Hot Start
2.3.1 Weld Arc Parameters
Weld Arc Parameters can be adjusted:
Rotate the SELECT knob until the required
parameter is highlighted RED in the top part
of the screen.
Press the SELECT knob to activate the
parameter.
Rotate SELECT knob to adjust the parameter.
Press the SELECT knob to De-activate the
parameter.
Continue to select other parameter, or
press Right Button to EXIT.
2.3.1.1 Hot Start
Rotate SELECT Volt Knob to adjust Hot
Start value from 0 to 100% of the set Weld
current. Hot Start will provide a boost
current at the arc start to help arc starting,
particularly on cold material.
2.3.1.2 Weld current
The Weld Current value can be adjusted.
Weld Current can also be adjusted from the
main weld screen.
2.3.1.3 Arc Force
Rotate Select Volt Knob to adjust Arc Force
value from 0 to 100% of the Weld Current.
Arc Force will boost the weld current and
therefore weld voltage, if the machine
weld voltage is too low due to short circuit
situation within the arc.
2.3.2 Machine Function
Press the Left hand Button to activate
the Machine Function selection. For Stick
mode, there are no Machine functions to
change.
