11
8.6
Solar Systems
Solar panel charged lubricator model uses the charger shown in
the picture. Cable connection is directly into the left hand side
screw terminals indicated on the charger.
The battery feed cable will have been factory connected, the free
end with ring terminals should be connected to the battery
terminals; blue core to negative and brown core to positive.
The round solar panel cable connects to terminals indicated with
the solar panel legend; Brown ‘+’, Blue ‘-‘
Damage will result if incorrectly connected.
The controller contains two indicator lamps:
A Green LED and this will be illuminated as soon as there is power from the module. When
the controller starts to limit the charge current the LED will flash.
The second LED can change colour from Red via Yellow to Green. Battery voltage is shown
by the colour and legend on the controller - Green full charge, Red low battery charge.
When the battery voltage falls below approximately 11v the multi colour LED will start to
flash FAST. While the battery remains at a low charge the LED will continue to flash slowly.
Warning!
This lubricator uses a 12v-115ah battery which contains an acid based fluid, the electrolyte. Care must be taken to avoid the electrolyte
coming in contact with the skin or clothing as the electrolyte may cause severe burns.
If the electrolyte contacts the skin wash with large quantities of clean water and seek medical advice.
DO NOT expose the battery to naked flames or cigarettes
During the charging process hydrogen gasses are vented from the battery and these gasses when mixed with the air may explode if
ignited.
Summary of Contents for LUBRICURVE ELECTRO 5
Page 30: ...30 ...
