2.
Low Battery Voltage Alarm/Shutdown Protection
a) When the input voltage from the 12 volt power source
drops below 10.5 volts, an audible tone will be heard.
This is the low battery voltage alarm.
b) The inverter will automatically shut down when the
input voltage drops below 9.5 volts. This protects the
battery from completely draining.
In the event of automatic shut down or continuous audible
a l a rm, turn the inverter rocker switch to the OFF (O) position
until the source of the related problem has been identified
and re s o l v e d .
Wall Mounting
:
Whistler inverters have provisions for wall mounting; two
slotted holes in the handle area and a notched area at the
power cord end allow for easy wall mounting of the unit.
Some Powerful Advice.
Your Whistler GO AC inverter will work best when placed on
a reasonably flat surface. The floor or seat of your car or tru c k
both are good locations.
When driving with the inverter in operation, make certain that
neither the inverter nor the power cords will impede safe
operation of your vehicle. Keep the unit and all cords clear of
the steering wheel, gas, brake and clutch pedals and gear
s h i f t .
14
ADDITIONAL FEATURES
CARE AND MAINTENANCE
To maintain your inverter in proper working condition, note
the following important safety pre c a u t i o n s :
•
MOISTURE. Keep the inverter dry. Do not expose it
to m o i s t u re. Do not operate the inverter if you, the
i n v e rt e r, the device being operated or any other sur-
faces that may come in contact with any power
sources are wet. Water and many other liquids can
conduct electricity which may lead to serious injury or
death.
•
HEAT. For peak efficiency, the ambient air tempera-
ture should be between 50° and 80° F. Avoid placing
the i n v e rter on or near heating vents, radiators or
other sources of heat. Do not place the inverter in
d i rect sunlight.
•
V E N T I L ATION. In order to disperse the heat generat-
e d while the inverter is in operation, keep it well venti-
lated. While in use, maintain several inches of clear-
ance around the top and sides of the inverter.
•
FUMES & GASES. Avoid using the inverter near
flammable materials. Do not place the inverter in
areas such as battery compartments, where fumes or
gases may accumulate.
In Review.
•
Never attempt to operate your Whistler inverter from
any power source other than a 12 volt battery or series
of batteries that total 12 volts.
15
PP750 Manual 3/6/02 2:25 PM Page 17