SC PRO
111519
Page 10 | 1-800-343-9463
PREPARING THE UNIT FOR INSTALLATION
The WhisperKOOL Unit requires a dedicated 115-volt, 15-amp circuit. The unit draws a large number of amps during its
initial startup. By designating a dedicated circuit breaker, you will guarantee the unit has enough power to run effectively.
Contact an electrician for assistance with the installation of this dedicated electrical circuit.
The unit must sit upright on a flat and level surface for 24 hours prior to testing and installation.
To prepare the unit for testing:
• Remove unit from box
• Place unit on tabletop
• Plug in unit to electrical outlet
• Plug in bottle probe
• Turn on to test for approximately 20–30 minutes
• Turn off after test
• Disconnect bottle probe
To prepare the unit for installation:
• Match the electrical outlet to the plug provided on the WhisperKOOL unit.
• Provide a dedicated circuit and wiring for the unit.
• Provide a weatherproof plug for units connected outside.
Power surges and spikes can damage sensitive electrical equipment. WhisperKOOL recommends plugging the unit into a surge
protector or power conditioner in order to protect your system. As outlined in our terms and conditions, power surges and spikes
are not covered under warranty.
We recommend that you do not use a GFI (ground fault interrupter) with this product.
Electrical Inlets
The unit is equipped with two power inlets. One is located on the right side of the unit (inside of the cellar), and the other is
located on the rear of the unit (outside of the cellar). Use the selector switch located on the right side of the unit to select which
power inlet you would like to use. If you would like to plug the unit into a socket outside of the cellar, set the selector switch to
rear. If you would like to plug the unit into a socket inside of the cellar, set the selector switch to the front position. When placed
in either position, power can only enter the unit utilizing the power inlet you’ve selected.
In case the unit should lose power, check the home/main circuit breaker. If the unit does not respond properly, refer to the
Troubleshooting Guide.
FRONT
REAR
Power Inlet
Front/Rear
Power Switch
Summary of Contents for SC PRO 2000
