GENERAL INFORMATION
6
M-GV/2, M-GV/3, M-GV/3+, M-GV 8, M-GV 10, M-GV 12 and M-GV 15
Ͷ
May 2018
Ͷ
EN
2
GENERAL INFORMATION
2.1
SAFETY
2.1.1
General
The user must always:
x
have access to the user's manual;
x
be familiar with the contents of this manual. This
applies in particular to the paragraphs on safety.
2.1.1
Warnings and symbols
Safety instructions and warnings are marked in this manual by
the following pictograms:
WARNING
This warning symbol draws attention to special
warnings, instructions or procedures which, if not
strictly observed, may result in damage or
destruction of equipment, severe personal injury
or loss of life.
WARNING
Moving machinery. This symbol indicates that a
potential hazard exists caused by moving parts
and draws attention to special warnings,
instructions or procedures which, if not strictly
observed, may result in severe personal injury or
loss of life.
WARNING
This danger symbol refers to toxic danger caused
by Carbon monoxide (CO) and draws attention to
special warnings, instructions or procedures
which, if not strictly observed, may result in
severe personal injury or loss of life.
DANGER
This danger symbol refers to electric danger and
draws attention to special warnings, instructions
or procedures which, if not strictly observed, may
result in electrical shock which will result in
severe personal injury or loss of life.
A procedure, circumstance, etc. requiring extra
attention.
2.1.2
Scope of regulations
When correctly installed and used under normal conditions, this
genverter fulfils EC safety regulations. This genverter could be
part of an installation or could be used in a way that additional
regulations of the EC or other authorities have to be taken into
account. Refer to the declaration of conformity/incorporation
included in this manual.
In certain situations, additional measures may be
necessary. Be aware of wet conditions, explosion
hazards,
etc.
2.1.4
Maintenance & repair
WARNING
When service has to be carried out while the
engine is running, be aware of moving parts.
If the genverter is switched off during
maintenance and/or repair activities, it should be
secured against unexpected and unintentional
switching on:
x
remove the DDC fuse from the local control
panel
x
remove the connections to the batteries
x
be sure that third parties cannot reverse the
measures taken.
Use original spare parts only. Always consult the manual before
carrying out maintenance.
2.1.5
Electrical safety
Warning signs indicate parts which could be live.
The alternator output (which is the inverter
input) can be as high as 400 Volt and is very
dangerous. The only way to get access to the high
voltage parts is with the help of tools. Never run
the genverter when there is access to these
parts. Touching these parts may result in
electrical shock which will result in severe
personal injury or loss of life.
x
Check all wiring at least once a year. Defects, such as loose
connections, burned cables, etc. must be repaired
immediately.
x
Do not work on the electrical system if it is still connected
to a current source. Only allow changes to your electrical
system to be made by qualified electricians.
x
Connections and protection must comply with local
standards.
2.1.6
Installation
WhisperPower genverters are not self-contained and have to be
properly installed. Installation involves proper ventilation, safe
electric connections, safe installation of the starting battery,
proper fitting of the cooling system and fuel pipes etc. In
enclosed areas, installation includes taking measures to outlet
exhaust fumes. Containing carbon monoxide, these are
extremely dangerous. Carbon monoxide (CO) is an invisible and
odourless gas. Inhalation produces headache, nausea or death.
Refer to the installation manual.
Do not use the genverter when the vessel is
inside a boat house or in other enclosed areas.
2.1.7
Operation
WhisperPower genverters have no external moving parts like
fans and V-belts. The fan of the radiator unit is covered by a
grid. The hot parts of the engine are covered by the sound
shield and therefore these genverters are very safe when the
sound shield is closed.
Nevertheless take note of the triangular signs on
the genverter indicating danger.
x
The genverter should be operated by authorized personnel
only.
