Automated Pet Care Products, Inc.
40 W. Howard, Suite B-5, Pontiac, MI 48342
Toll Free: 877-250-7729 Fax: 248-253-1797
www.Litter-Robot.com
34
How do I clean the Litter-Robot exterior?
Cleaning the Litter-Robot exterior is easy. Just remove
the Globe and the drawer and give them a sponge bath,
or take them outside for deep cleaning with the garden
hose. All other surfaces can be wiped clean but should
not be submerged.
CAUTION:
The Base of the Litter-Robot contains
electrical components and is not meant to be
submerged or wet.
See the “Cleaning the Litter-
Robot” section for more details.
What are the dimensions of the Litter-Robot?
•
The fully assembled Litter Robot is 27 ½” high, 21
½” wide and 24” deep.
•
The waste drawer is 10 ½” wide, 13” long and 4”
deep.
•
The oval shaped entry for the cat is 8 ¾” high and 6
½” wide.
•
The litter bed area measures 14” across at
maximum litter capacity.
•
There is 13” to 15” of head room for the cat inside
the Globe depending on the level of litter. The
inside width is 20” across at the widest point, and
depth is 15” front to back.
Automated Pet Care Products, Inc.
40 W. Howard, Suite B-5, Pontiac, MI 48342
Toll Free: 877-250-7729 Fax: 248-253-1797
www.Litter-Robot.com
35
Troubleshooting
1.
All lights on the Control Panel are blinking once per
second.
If the Globe cannot find the home position, all three
lights on the Control Panel will blink at a rate of
once per second. Make sure the Litter-Robot is on a
level surface. If the condition persists, please
contact Customer Service.
2.
Yellow light on the Control Panel is on.
The Yellow light comes on when a cycle is
interrupted by the Cat Sensor. The Litter-Robot will
wait 2 minutes before resuming the cycle. If the Cat
Sensor is continuously interrupted for more than two
minutes the Litter-Robot will stop and the Red light
will start flashing.
3.
Red light (“Sensor/Timing”) on the Control Panel is
flashing.
This condition indicates that the Cat Sensor was
triggered for more than two minutes.
a.
Check to see that the Litter-Robot is on a
level surface.
b.
Make sure that there is no excess litter in
the Globe. The litter level should be at least
two inches below the bottom rim of the cat
entry opening.
