11
11
Your dishwasher may not work properly.
Before contacting the Service Centre check if the problem can be solved by going through the following list.
TROUBLESHOOTING
MAINTENANCE AND TROUBLESHOOTING GUIDE
For more information, see the Use and Care Guide
The Use and Care Guide can be obtained by:
• After-Sales Service; phone number see in warranty booklet.
• Download from website: www.whirlpool.com.hk
When you contact the After-Sales Service, you
must provide the codes shown on the rating
plate attached to the left or right side inside the
door of the dishwasher. The phone number is
listed in the warranty booklet or on the website:
www.whirlpool.com.hk
IEC 436
:
PROBLEMS POSSIBLE CAUSES
SOLUTIONS
The dishwasher
won’t start
or does not
respond to
com-mands.
The appliance has not been plugged
in properly.
Insert the plug into the socket.
Power outage.
The dishwasher starts automatically when the power returns.
The dishwasher door is not closed.
Vigorously push the door until you hear the “click”.
It does not respond to commands.
Switch off the appliance by pressing the ON/OFF button, switch it back
on after approximately one minute and reset the program.
The dishwasher
won’t drain.
nishes.
The drain hose is bent.
Check that the drain hose is not bent (see INSTALATION INSTRUCTION).
The sink drain pipe is blocked.
Clean the sink drain pipe.
Clean the fi lter (see CLEANING THE FILTER ASSEMBLY).
The dishwasher
makes
excessive noise.
The dishes are rattling against each.
Position the crockery correctly (see LOADING THE RACKS).
An excessive amount of foam has
been produced.
The detergent has not been measured out correctly or it is not suitable for
use in dishwashers (see FILLING THE DETERGENT DISPENSER)
.
Reset dishwa-
sher by pressing the DRAIN button (see OPTIONS AND FUNCTIONS) and run
new program without detergent.
The dishes are
not clean.
The crockery has not been arranged
properly.
Arrange the crockery correctly (see LOADING THE RACKS)
.
The spray arms cannot rotate freely,
being hindered by the dishes.
Arrange the crockery correctly (see LOADING THE RACKS)
.
The wash cycle is too gentle.
Select an appropriate wash cycle (see PROGRAMS TABLE)
.
An excessive amount of foam has
been produced.
The detergent has not been measured out correctly or it is not suitable for use
in dishwashers
(see FILLING THE DETERGENT DISPENSER)
.
The cap on the rinse aid compartment has
not been shut correctly.
Make sure the cap of the rinse aid dispenser is closed.
.
d
e
g
g
o
l
c
r
o
d
e
li
o
s
s
i
r
e
tl
if
e
h
T
y
l
b
m
e
s
s
a
r
e
tl
if
e
h
t
n
a
e
l
C
(see CARE AND MAINTENANCE).
There is no salt.
Fill the salt reservoir (see FILLING THE SALT RESERVOIR)
.
CONTACTING AFTER-SALES SERVICE
Summary of Contents for WSFE2B19UK
Page 1: ...使用說明書 Model WSFE2B19UK 產品型號 WSFE2B19UK User Manual ...
Page 2: ...2 繁體中文 3 16 ...
Page 15: ...15 a b a c 4 5 6 7 15 001 ...
Page 28: ...28 a b a c 4 5 6 7 15 001 ...