Whirlpool WSFE2B19UK, User Manual

Page: 10 / 28

10
EN
10
CLEANING THE FILTER ASSEMBLY
Regularly clean the filter assembly so that the filters do not clog
and that the waste water flows away correctly.
The filter assembly consists of three filters which remove food
residues from the washing water and then recirculate the water: to
obtain the best washing results, you need to keep them clean.
The dishwasher must not be used without fi lters or if the fi lter
is loose.
After several washes, check the filter assembly and if necessary clean it
thoroughly under running water, using a non-metallic brush and follo-
wing the instructions below:
1. Turn the cylindrical fi lter A in an anti-clockwise direction and pull
it out (Fig 1).
2. Remove the cup fi r e tl B by exerting a slight pressure on the side
fl aps (Fig 2).
3. Slide out the stainless-steel plate fi r e tl C (Fig 3).
4. Inspect the trap and remove any food residues. NEVER REMOVE
the wash-cycle pump protection (black detail) (Fig 4).
After cleaning the filters, re-place the filter assembly and fix it in
position correctly; this is essential for maintaining the efficient
operation of the dishwasher.
A
A
B
C
CLEANING THE SPRAY ARMS
On occasions, food residue may become encrusted onto the
spray arms and block the holes used to spray the water. It is therefore
recommended that you check the arms from time to time and clean
them with a small non-metallic brush.
To remove the upper spray arm, turn the plastic locking ring in an
an-ti-clockwise direction. The upper spray arm should be replaced so
that the side with the greater number of holes is facing upwards.
The lower spray arm may be removed by pulling it upwards.
CLEANING THE WATER INLET HOSE
If the water hoses are new or have not been used for an extended
period of time, let the water run to make sure it is clear and free of
impurities before performing the necessary connections. If this
precaution is not taken, the water inlet could become blocked and da-
mage the dishwasher.
CARE AND MAINTENANCE
1 2
3 4