12
CONNECT INLET HOSE
(STEAM MODELS)
The dryer must be connected to the cold water faucet using the new
inlet hoses. Do not use old hoses.
1.
Turn cold water faucet off and remove washer inlet hose.
2.
Remove old rubber washer from inlet hose and replace with new
rubber washer provided. If space permits, attach the brass female
end of the “Y” connector to the cold water faucet.
NOTE:
If “Y” connector can be attached directly to cold water
faucet, go to Step 6. If “Y” connector cannot be attached
directly to the cold water faucet, the short hose must be used.
Continue with Step 3.
3.
Attach short hose to cold water faucet. Screw on coupling
by hand until it is seated on faucet.
4.
Using pliers, tighten the couplings with an additional two-thirds
turn.
NOTE:
Do not overtighten. Damage to the coupling can result.
5.
Attach “Y” connector to brass male end of small hose. Screw
on coupling by hand until it is seated on connector.
6.
One end of the long hose has a wire mesh strainer inside
the coupling. Attach this end to the “Y” connector.
7.
Attach washer cold inlet hose to other end of “Y” connector.
Screw on coupling by hand until it is seated on connector.
A
A. Inlet to cold water
8.
Using pliers, tighten the couplings an additional two-thirds turn.
NOTE:
Do not overtighten. Damage to the coupling can result.
9.
Attach other end of long hose to fill valve at bottom of dryer back
panel. Screw on coupling by hand until it is seated on fill valve
connector.
3
3
/
4
"
(95 mm)
11"
(368 mm)
10.
Using pliers, tighten the coupling an additional two-thirds turn.
NOTE:
Do not overtighten. Damage to the coupling can result.
11.
Check that the water faucets are on.
12.
Check for leaks around “Y” connector, faucet, and hoses.
LEVEL DRYER
Check the levelness of the dryer by first placing a level on the top
of the dryer near the console.
Then, by placing a level in the crease on the side of the dryer
between the top of the dryer and the dryer cabinet, check
the levelness from front to back.
If the dryer is not level, prop up the dryer using a wood block. Use a
wrench to adjust the legs up or down and check again for levelness.
Summary of Contents for WGD7600XW0
Page 31: ...31 NOTES ...
