10
Make Electrical Connections
IMPORTANT:
■
Electrical wiring, disconnect means and over-current protection
are to be supplied by the installer. Refer to the rating plate for the
maximum over-current protection, minimum circuit ampacity, and
operating voltage. See wiring diagrams later in this section.
■
Install an adequately-sized branch circuit disconnect,
according to the NEC, within sight of and readily accessible
from heat pump.
■
The cable or conduit and fittings connected from the
disconnect to the heat pump shall be rated for outdoor use.
Single Phase Electrical Connections
Refer to “Outdoor Unit Typical Wiring Diagram.”
1. Disconnect power.
2. Remove control box cover.
3. Connect the field supply wires L1 and L2 to contactor
terminals L1 and L2.
Cooling—2nd Stage (High Capacity)
65 (18)
216
146
215
139
235
141
255
132
75 (23.9)
261
146
260
141
278
143
297
134
85 (29.4)
293
147
306
142
321
144
340
135
95 (35)
352
148
315
144
364
146
382
137
105 (40.6)
397
149
396
146
407
148
424
139
115 (46.1)
443
150
442
147
450
149
467
140
Heating—1st Stage (Low Capacity)
40ºF
292
104
303
95
313
92
333
89
50ºF
312
110
320
112
333
108
359
105
Heating—2nd Stage (High Capacity)
20º
268
55
284
63
281
59
312
58
30ºF
298
73
302
78
287
73
334
71
40ºF
327
91
321
94
307
87
357
85
50ºF
357
109
340
110
328
101
380
98
NOTE: Values provided are typical pressures. Indoor unit match-up, indoor air quality and indoor load will cause pressures to vary.
W4GH824A
W4GH836A
W4GH848A
W4GH860A
Air Temperature Entering
Outdoor Coil ºF (ºC)
Liquid
Suction
Liquid
Suction
Liquid
Suction
Liquid
Suction
WARNING
Rating Plate Ampacity
Less than 15
16 - 20
21 - 30
AWG
14
12
10
8
31 - 50
Electrical Shock Hazard
Electrically ground condensing unit or heat pump.
Connect ground wire to ground lug.
Use copper wire for supply connection.
Correct wire gauge is shown in the chart below.
Failure to follow these instructions can result in
death or electrical shock.
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.