18
1.
Remove red cap from gas pipe on back of dryer.
2.
Connect gas supply to dryer. Use a pipe thread compound
approved for the type of gas supplied. If flexible metal
tubing is used, be certain there are no kinks.
If necessary for service, open the front lower service panel
by using a 1/4" nutdriver to remove the 2 hex-head screws
from the bottom of the panel. Then lift up on the panel while
pulling the bottom of the panel away from the dryer.
3.
Open the shut-off valve in the gas supply line and make sure
the dryer has its own gas supply opened.
4.
Test all connections by brushing on an approved
noncorrosive leak-detection solution. Bubbles will show
a leak. Correct any leaks found.
Make Gas Connection
INSTALLATION INSTRUCTIONS – GAS DRYER
