Whirlpool UltraPure AP33, Owner'S Manual

Page: 11 / 38

To Operate
Press the power/mode key for automatic operation.
Sensors take about 30 seconds to start working.
Press the key again to change operation as follows:
Following stable installation, insert the mains plug.
#WVQOCVKE /CPWCN
Operation by the main unit
Stop
mode: sets airflow according to air quality. (does not switch to turbo operation)
Anti Allergy (AA) mode: alternates airflow automatically.
Manual mode: runs at selected airflow irrespective of air quality.
Anti Allergy(AA)
.Q Turbo
Main unit cannot set timer, negative ions or cleanness level light. Use remote.
If sensor detects clean air quality for 30 minutes consecutively, 'Low' airflow is set and the
UV light extinguishes.
In auto mode the dust and gas sensors monitor air quality. These record quality in by the
3 stages of cleanness light and adjust airflow accordingly. (Unit operates at the higher of
the two readings)
Since sensor sensitivity varies according to the condition of the room, adjust sensors as
required between 'Lo' and 'Hi'
(Factory setting is 'Lo')
࡮ Dust sensor
Detects airborne particles such as pollen, domestic dust, tick bodies and droppings
and smoke.
Dust quantity differs from visible dust, so the cleanness level light indication may
appear different from that expected.
࡮
Gas sensor
Detects airborne gases such as kitchen rubbish, toilet, pet and smoke smells. (May
also react to rapid changes in temperature or humidity)
The sensor may react to, for example, makeup, but this does not cause failure of the
unit.
Sensor sensitivity switch
Mid Hi