Installation Instructions
cont.
9
copper
tubing
quick-connect
fitting
water supply
line
saddle
valve
13.
Connect water supply line
from saddle valve to spout copper
tubing with the factory-assembled
quick-connect fitting. Push water
supply line tubing straight into fitting
as far as it will go. Pull on tubing.
The tubing should not come out
when properly installed. Turn the
saddle valve handle counterclockwise
to open water line.
NOTE: If you need to remove tubing,
push down on collet. Pull tubing out
of quick-connect fitting.
On
14.
Turn Temperature Control
counterclockwise to “Off” position.
15.
Push down and turn the
On/Off Cap clockwise to open spout.
Hold cap open to fill tank (about 1
minute). When tank is full, water will
flow from spout. Release cap.
16.
Plug power supply cord into
grounded outlet.
Turn Temperature Control clockwise
to highest position.
Water in tank will reach maximum
temperature in approximately
15 minutes.
When water is heating, you may hear
gurgling noises coming from the tank.
There may also be some spitting or
hot water flow from the faucet. This is
normal for the initial heat-up of the
dispenser.
Turn Temperature Control to lower
temperature setting if you notice
vapor or hear boiling noise.
NOTE: Temperature Control
controls tank heater, not water
delivery. Rotate Temperature
Control clockwise to raise water
temperature, counterclockwise to
lower water temperature.
NOTE: Do NOT plug power supply cord into outlet.
NOTE: Turn Temperature Control to
“Off” position before plugging hot
water dispenser into power supply.
If tank is empty and thermostat is
in an “On” position when the
power supply cord is connected,
the heater will overheat causing
an unpleasant taste, black specks
in the water, and permanent
damage to the heater seals.
