24
If you experience
Possible Causes
Solution
Water Leaks (cont)
Water or suds leaking from door or rear
of cabinet
Leaking around door
• Using too much detergent.
• Hair, lint, or other debris on inner
door glass preventing proper seal with
rubber door seal.
• Suds from regular detergents can
cause leaking from the door or rear of
cabinet. Always measure detergent and
follow manufacturer’s directions based
on your load requirements.
• Clean inner door glass and seal.
Wash cycle not performing as expected
Load not completely covered in water
Washing machine won’t run or fill;
washing machine stops working
• Water level not visible on door or does
not cover clothes.
• Check for proper water supply.
• Check proper electrical supply.
• Normal washing machine operation.
• The washing machine door is not
firmly shut.
•The 6thSense Precison Dose is not fully
seated in the washing machine.
• Washing machine not loaded as
recommended.
• Using too much detergent.
• This is normal for the washing
machine. The washing machine senses
load sizes and adds the correct amount
of water for optimal cleaning.
• Hose must be attached and have water
flowing to the inlet valve.
• Water faucet must be turned on.
• Check that inlet valve screen has not
become clogged.
• Check for any kinks in inlet hose, which
can restrict water flow.
• Do not use an extension cord.
• Ensure there is power to outlet.
• Check electrical source or call an
electrician to check if voltage is low.
• Reset a tripped circuit breaker. Replace
any blown fuses.
NOTE:
If problems continue, contact an
electrician.
• Washing machine will pause during
certain phases of cycle. Do not interrupt
cycle.
• The washing machine pauses for
about 2 minutes during certain cycles.
Allow the cycle to continue.
• Washing machine may be stopped to
reduce suds. Use only a proper amount
of detergent.
• The door must be closed during
operation.
• Make sure that the 6th Sense Precison
Dose is fully seated in the washing
machine, and that the lid on the bulk
dispenser is firmly closed.
• Remove several items, rearrange
load evenly in washing machine drum.
Close door and touch the START/PAUSE
button.
• Do not add more than one or two
additional items after cycle has started
to avoid tightly packing or unbalancing.
Adding items is only allowed up to a
certain point in the cycle.
• Do not add more water to the washing
machine.
• Suds from regular detergents can
slow or stop the washing machine.
Always measure detergent, following
manufacturer’s directions based on
your load requirements.
• To remove suds, cancel cycle. Select
Rinse & Spin. Touch the START/PAUSE
button. Do not add more detergent.
