Installation Manual: GT500 FRPP Supercharger System (750HP) (A1R2)
Last Updated: Aug 19
th
, 2010
Page 24 of 35
81.
Install supplied SVT airbox with 123mm MAF housing into factory location. Secure with factory fasteners. allen
wrench), torque to 100 in/lbs.
Loctite™ (#271 red) threads.
82.
Reconnect the MAF connector to the MAF element.
Install the supplied hump hose to the factory throttle body and secure to throttle body using the
supplied (1) #72 hose clamp (5/16" nut driver).
Install the supplied 4" silicone hose over the plastic inlet duct as well as the (2) supplied #64 hose
clamps. Slide the silicone hose as far up as possible for easier installation of the plastic air inlet
ducting.
Install the oval end of the plastic air inlet duct to the throttle body/hump hose and lift up, install the
vent hose to the 3/8" plastic barb. Line up the plastic duct with the MAF housing. Secure the hump
hose side with the supplied (1) #72 hose clamp (5/16" nut driver) Secure the MAF to plastic duct hose
with the supplied (2) #64 hose clamps (5/16"nut driver).
83.
Reinstall coolant reservoir with factory hardware.
84.
Fill the new s/c compressor with oil per supplied instructions.
!!
CAUTION
!!
