WHARTON 4000x Series, Operating And Installation Instruction

Page: 10 / 16

4000x Series Digital Clock
Operating and Installation Instructions
7 - Synchronisation Setup
The 4000x series digital clocks have a standalone accuracy of be er than 0.1 sec/day @ 20-25ºC. However,
for applica ons where an increased level of accuracy is required, units may be synchronised to a range of
different synchronisa on methods.
The synchronisa on se ngs are accessed from the func on menu as detailed in sec on 3.
Fu Sy Synchronisation settings
Sync
Mode
Description
N N
E
E E
P
Mode Range Option Description
None Stand alone opera on Y Y Y Y
NTP NTP synchronisa on on 10/100Base-T Ethernet TCP/IP network. Y Y
DHCP or
IP address
If Clock is set to ‘Full DHCP’ mode it obtains its ntp server address from the
customers DHCP server. If sta c or DHCP mode is selected the address of the
first NTP server should be entered.
GPS GPS satellites synchronisa on
(requires 488HS3 or 488HS3-GLONASS receiver)
Y Y Y
48x0 High precision UTC synchronisa on code for exis ng 5200 or 4860 series master
clock.
Y Y Y
482 w482 Time code from exis ng 5200, 4860 or 482D series master clock. Y Y Y
Zo 1-F w482 me code zone that unit will use for synchronisa on.
DCF DCF77 Radio me code synchronisa on
(requires 484.03 radio receiver)
Y Y
MSF MSF60 Radio me code synchronisa on
(requires 484.02 radio receiver)
Y Y
MOBA MOBA Line me code from ETC or DTS series master clock. Y Y Y
Of +720 ->
-720
Offset in minutes of input MOBALine me signal to UTC (in winter me)
1PPS Contact your local distributor for further informa on.
SER RS232 (requires 4040.2) or RS485 (requires 4040.4) serial ASCII me
synchronisa on
Y Y Y
St WF1, WF2, LUL1,
LUL2, LUL3, GPZDA
Time synchronisa on from specific format serial message. Contact your local
distributor for further informa on.
Ba 12 -> 57 Baud rate from 1200 - 57,600 baud
Bit 7, 8 7 or 8 data bits
Par Non, Eve, Odd Parity: None, Even or Odd
IRIG 1KHz Amplitude Modulated IRIG-B(requires 4040.I) Y Y
EBU 24, 25, 29.97 & 30 fps EBU/SMPTE LTC mecode (requires 4040.E) Y Y
Opt Fiber op c me synchronisa on - Contact factory for more info.
AirT AirTime Radio synchronisa on (requires 4040.AT + AirTime RF module) Y Y
Imp 24V Alternate polarity impulse support (4000EP only) Y
im 1sec, 30s, 1min 1 second, half minute or 1 minute impulses
10 Issue 2.2