3
Mount the unit
INSTALLATIONS
When removing the unit from the installation sleeve
If you need to remove the unit from the installation sleeve, proceed as follows:
1. Remove the rear supporter from the unit.
2. Remove the control panel from the unit. (Refer to the operating instructions.)
3. Remove the trim from the unit.
4. Insert two levers into the pair of grooves on both sides of the unit, and pull the levers toward you
to remove the unit from the installation sleeve.
INSTALLATIONS WITHOUT USING THE SLEEVE
In the case of Toyota cars, etc., first remove the existing car stereo and then install the unit in its place.
1. Remove the trim plate in the direction of the arrow.
2. Attach the existing mounting bracket (not supplied) to the unit. Make sure to use the screws (M5 x
8 mm) (not supplied). Using longer screws may damage the unit.
Screws
(M5 x 8mm)
Screws
(M5 x 8mm)
Mounting bracket
Trim plate
Dashboard
Installation sleeve
Fire wall
Note
Bend the claws
according to the
thickness of the
dashboard.
Screw
Spring washer
Washer
Washer
Supporter
Nut
Spring washer
