WFT 1D-A 703-020, Manual, Page: 40 / 48

16
1 2 3
5 4
1
AUTO STOP JIGGING
SURFACE
RANGE/BOTTOM
RANGE / BOTTOM
Correction of oroginal line cut :
1. Wind up the line back on the spool (4) .
2. Press “RANGE/BOTTOM“ switch for 3 seconds.
Thereafter is a signal, and display shows 0.0 and OK
(5) .
Please note :
- Correction of original line cut is a tip in case original line more than 10 m is cut.
- After correction of original line cut, please reset up the “Side Of Boat“ and the “Surface Of Water 0“.
- If the “ON/OFF“ switch is pushed for more than 3 seconds at the position “0.0“ of the main counter.
Operating methods
Push
“RANGE/BOTTON“
for 2 seconds
shown while
winding up
Distance From Ground
is set to zero
Recounter the
dropped line
Push
“RANGE/BOTTON“
once
Push
“RANGE/BOTTON“
for 2 seconds
The “Bottom Mode“ and controlling of “Distance From Ground“ :
To switch over from “Swimming Range“ Mode to “Bottom Mode“ :
1. Hold “RANGE/BOTTOM“ switch for two secons,
now below the depth of water on main display the “Distance From Ground“ is indicated
with smaller numerals (sub counter). The value first is 0.0 (1) .
Until you wind up the line, the main display shows the depth of your bait,
during the sub counter shows the “Distance From Ground“ (2) .
2. Anytime you can set the “Distance From Ground“ to 0.0 again
by pushing the “Range/Bottom“ switch shortly
(3)
.
Switch from Ground- to Depth-Mode :
To deaktivate “Distance From Ground“ mode push “RANGE/BOTTOM“ switch for 2 seconds.
Please note : It is not possible to set -Distance From Ground- to zero while using the motor.
If you hold “Range/Bottom“ longer than 5 seconds,
“Distance From Ground“ and “Bottom Mode“ are switched off completely.