WD-59CTS & WD-66CTS
Rev. (202210)
Operating instructions
48
In addition to the faults shown on the touch panel, other faults can occur. The
table below shows some faults which can be rectified by the operator.
All errors displayed on the touch panel have an error code, which is displayed in
the alarm. This error code must be specified when contacting service personnel.
When you contact service personnel, you will need to provide the following
information:
•
Machine type and model.
•
Machine serial number and date when the machine was installed.
•
A brief description of the problem. Are any error codes shown on the touch
panel?
•
What happened/was being done immediately before the fault occurred?
Troubleshooting
Problem
Cause
Action
Noise from the washing
pump.
Foam in the tank.
Change the water.
The machine is not
cleaning properly.
For causes and actions, see "4.2.8 Checking the wash result".
The dishware tips over.
The dishware is too light.
Put the dishware in baskets. Use a mesh grid to
hold the items in place.
Washing pressure is too high.
If the machine is equipped with Quick setting for
washing pressure (option): Check that the lever
is set to the position for “Normal loads”.
The upper wash arms in the
chemical, pre-wash or final
rinse sections are clogged.
Clean the wash arms!
Dishware does not dry.
The rinse nozzles are blocked.
Check and clean the nozzles.
Too little drying agent.
Check the quantity of drying agent.