WD-59CTS & WD-66CTS
Rev. (202210)
Installation instructions
15
•
Check that the section is horizontal using a spirit level against the tank
body.
•
Fit the stainless steel clamp strips inside the machine above the rim of the
hood and tank, and above the joints between both sections (see the arrows
in the figure below). Fit the upper clamp strip first. Apply a small amount of
silicone to the strips before fitting them into place.
Positioning of clamp strips in the joints between both machine sections
•
Seal the joint between the sections on the outside of the machine (back and
top) using silicone. Attach masking tape to both sides of the joint and fill the
joint with silicone.
•
Fit the upper cover plate between the sections. The bottom section of the
cover plate must sit inside the tank body and the upper section must be
pushed down behind the door guides.
35-1-00-008
35-1-00-009_R1