WD-4S
Rev. 5.0 (201912)
Installation instructions
20
If equipment for a different type of detergent is used, it should preferably be put
on the wall behind the machine to avoid holes being drilled unnecessarily in the
machine.
The detergent hose is connected to the pipe (A) at the front end of the chemical
washing tank (see the figure below).
The measuring cell for measuring the concentration of detergent in the washing
water must be put in the front end of the tank. On the inside of the tank next to the
heating element, the letter “C” is stamped into the metal to mark where the hole
should be drilled.
When drilling holes, it is important that the following points should be observed:
•
Use sharp tools so that panels do not become unnecessary hot. Red-hot
panels can rust in the future.
•
Remove all metal shavings carefully both from the machine and tank be-
fore refilling with water. Shavings left in the tank can cause corrosion.
A=Connection in the tank
B=Marking for measuring cell in the front end of the tank
4S_tank
A
B
