WD-215T
Rev. 6.0 (201812)
Instructions for use
45
Troubleshooting
In addition to the faults shown on the control panel other faults can occur. The ta-
ble below shows some faults which can be rectified by the operator. If the problem
persists, contact authorised service personnel.
When you contact service personnel, you will need to provide the following infor-
mation:
•
Machine model
•
Machine serial number and date when the machine was installed.
•
A brief description of the problem.
•
What happened immediately before the fault occurred
(75)
FINAL RINSE ERROR
LOW FLOW IN
THE MACHINE
Clean the nozzles. Reset the alarm by pressing button (9). If the error recurs,
contact an authorised service company.
(90)
ADJUSTED MACHINE
CAPACITY OVERRIDDEN
Leave more time between feeding in trays.
(83) TIME FOR
MAINTENANCE
CONTACT:
Reset the alarm by pressing button (9). If the error recurs, contact an authorised
service company.
ALARM MESSAGE
ACTION
Troubleshooting
Problem
Cause
Action
No indication on the control panel
display when the power is switched
on.
The main switch is off.
Turn on the mains switch (14).
The machine does not fill with water.
The shut-off cock on the incoming
water supply is closed.
Open the tap.
The machine does not stop filling.
Level pipe (22) is not in place.
Fit the level pipe.
The level pipe's rubber sleeve is not
sealing against the bottom plate.
Check that the level pipe is closed.
Change the rubber sleeve if it is da-
maged.
Washing pump is noisy.
Low water level in the tank.
Check that the level pipe is closed.
Change the rubber sleeve if it is da-
maged.
Foam in the tank.
Change the water.
The machine is not cleaning proper-
ly.
The rinsing and washing nozzles are
clogged with dirt.
Check and clean the nozzles.
There is too little detergent.
Check the amount of detergent.
Foam forming in the washing tank.
Check that the washing temperature
is not too low and that the correct de-
tergent is being used. Change the
water if foam forms.
Dirt has dried on the trays.
Soak the trays before washing.
The water in the tank is too dirty.
Change the water.
The trays do not dry.
The rinsing nozzles (15) are block-
ed.
Check and clean the nozzles.
Too little drying agent.
Check the quantity of drying agent.
Summary of Contents for WD-215T
Page 51: ......