WD-12S
Rev. (202103)
Installation instructions
15
3.5.4
Detergent and drying agent
•
Check what your machine is equipped with, as this may vary depending on
market. The equipment will be roughly set at the factory if the machine is
equipped with any of these alternatives. Contact your chemical supplier for
a more precise setting.
•
Use the same make and type of detergent and drying agent.
•
With machines connected to cold water, the water pipe temperature may
be too low for use of powder or paste type detergents.
•
If liquid detergent is used together with Wexiödisk’s detergent pump, the
detergent must be placed under the machine’s tank level.
If equipment for a different type of detergent is used, it should preferably be put
on the wall behind the machine to avoid holes being drilled unnecessarily in the
machine.
Detergent hose connections on both sides of the tank
The measuring cell for measuring the concentration of detergent in the washing
water is located on the left-hand side of the tank (viewed from the front) and hole
markings for drilling are shown.
When drilling holes, it is important that the following points should be observed:
•
Use sharp tools so that panels do not become unnecessary hot. Red-hot
panels can rust in the future.
•
Remove all metal shavings carefully both from the machine and tank
before filling with water. Shavings left in the tank can cause corrosion.
For information about electrical connections, see the wiring diagram.
The process of setting the detergent and drying agent dispenser is described in
the ADJUSTMENT INSTRUCTIONS.
