11
Controls and Gauges – cont’d
Steering Column Controls
Light Switch/Turn Signal
: The multifunction lever is on the left hand side of the steering wheel.
Turn Signals
: Pull lever down until it latches to signal a left turn and push it up for a right turn.
The indicator lights on the instrument panel will indicate a left or right turn. When the turn is
r
u
t
e
h
t
fI
.
l
a
n si
gn
r
u
t
e
h
t
l
e
c
n
a
c
l
li
w
l
e
e
h
w
g
n
ir
e
e
t
s
e
h
t
e
t
e
l
p
m
o
c
n signal continues to
pull
the turn signal switch back to OFF position.
Dimmer Switch
: To change your headlamp from low to high beam, push the lever away from you,
until it latches and release. The blue high beam indicator on the dash glows when the headlamps
are on high beam. To change your headlamp from high to low beam, pull the lever toward you and
release. Flash to Pass: Pull the lever toward you and hold to momentarily turn on the high beam.
Lights
: Rotate the knob on the end of lever to the st position. This activated the clearance,
parking, license, and taillights. Turn knob to second position to activate headlights, license, and
taillights.
Daytime running lights
: Once the vehicle is running the daytime running lights automatically
come on. These however should not be used for night driving.
Tilt Adjustment: Tilt steering with a lever on the right side lower steering column. Pull the lever out from the center
section.
Wiper Control:
Located on the right hand side of the steeri ng column. Move stalk down to select wiper
speed. When the wiper is on the INT (intermittent) setting, rotate knob on end of stalk to select desired
intermittent setting.
Dome Light:
Located on the ceiling in compartment. Push switch on dome light to illuminate it. Push
again to shut it
Wi per Control
Light Switch/
Turn Signal
Contact Westward Industries for Manuals and Documentation. Do not copy.
