Westric SW Series, Installation, Operation And Maintenance Manual

Page: 20 / 20

76-5023-05 Page 20 of 20

Alarm reset
To reset the beeping alarm signal press G
To reset the display and the output of dry contacts, press D on M models sequencers, provided that the problems
that caused the fault have been normalised, otherwise the alarm will be triggered again.
In
A models, the display and dry contact output are automatically reset when the causes that generated the fault
disappear.

Manual cycle
In order to facilitate maintenance work and testing of the units, it is possible to manually cycle the units in the
following way:
Press from the room temperature display:
D
 
G

Customer service
If you have any questions regarding the installation, programming or use of this product, please contact Westric´s
Electronic Department at +5411-4715-2522.