Weston PRO-3500, Manual

Page: 8 / 33

VACUUM SEALER CANISTERS
(SOLD SEPARATELY)
Vacuum canisters may
be used with the Vacuum
Sealer (Sold Separately).
Vacuum canisters come
with their own hose.
1. Attach the Vacuum Sealer
to the power supply.
2. Press the Power Button
on the Control Panel to turn
the Vacuum Sealer “ON”.
The Power Indicator will
turn green and the Internal
Cooling Fan will run.
3. Insert one end of the
accessory hose into the
Accessory Port on the
Vacuum Sealer.
4. Insert the other end of the
accessory hose into the port
on the lid of the canister.
5. Fill the canister with
the product to be vacuum
sealed.
6. Turn the knob/dial on the
canister to the seal position.
7. Press the Canister Button. This will engage the Vacuum Pump.The
appliance will stop automatically when the seal process is complete.
8. Gently remove the accessory hose from both the canister and the Vacuum
Sealer. Wait at least 30 seconds before vacuuming another canister to avoid
overheating the unit. Be careful not to turn the knob/dial of the canister to the open
position.
9. To test vacuum, gently tug on the canister lid. The lid should not move.
10. To release the vacuum and open the canister, turn the knob/dial on the
canister to the open position.
11. Press the Power Button on the Control Panel to turn the Vacuum Sealer
“OFF”.
12. Disconnect the Vacuum Sealer from the power supply.
ENGLISH INSTRUCTIONS
14
Canister button
Accessory Hose
(sold separately,
with canister)
Canister
(sold separately)
Accessory
Port
1. To create bags using the roll holder, remove the roll holder rod from the
cilps at the back of the vacuum sealer.
2. Slide the rod through the center opening of the roll (will hold bags up to
11” wide).
3. Fold the roll holder arms out and rest the rod in the slots on the roll holder
arms, carefully lining up the notches in the rod with the slots in the arms.
4. It is easier to cut bags from the roll when the bags are rolled over the roll
(as opposed to under the roll).
5. Move the bag cutter towards the lid and pull the vacuum bag over the
cutter slot until you have reached the desired length.
6. Move the bag cutter back over the top of the bag roll, making sure the
blade is to one side.
7. Slide the blade across the bag roll to cut your roll into your custom bag
size.
USING THE ROLL HOLDER & CUTTER
INSTALLING LID LATCHES
Optional Lid Latches & screws are included with this unit, packaged in a bag
separate from the unit. Gently pressing the lid down while vacuuming and
sealing will ensure a quality seal and allow you to use the machine without
the latches. Over time, the Oval Vacuum Chamber Seals will wear. We rec-
ommend replacing these if you find that your seal quality is decreasing over
time. These latches will extend the life of your Oval Seals and ensure a more
quality seal if your machine begins to experience wear.
1. To install latches, simply use a Phillips Head Screw Driver
(not included)
to
screw the latches into the holes at the front of the machine.
Screws
Lid
Latch
Vacuum
Sealer
Body
Vacuum
Sealer Lid
ENGLISH INSTRUCTIONS
15
Lid
Latches