Westlab 665-090, Product Manual, Page: 7 / 12

7
PRODUCT MANUAL
1800 358 101
sales.au@westlab.com
www.westlab.com.au
+64 9 553 3677
sales.nz@westlab.com
www.westlab.co.nz
646 568 5391
sales.us@westlab.com
www.westlab.com
1 877 822 1455
sales.ca@westlab.com
www.westlab.com
Australia New Zealand United States Canada
Number Name Description
1 Display The display shows the set speed and the time value.
It also displays the selected program when the unit is
in Prog. Mode.
2 Speed Press the ‘Speed’ button to select the speed value and
use the increment and decrement button to set the
required speed.
3 Time Press the ‘Time’ button to select the time value and
use the increment and decrement button to set the
required run time.
4/5 Increment/
Decrement
Press the ‘Increment/Decrement’ button to set the
required value of speed, time or program [Prog. Mode].
6 Start/Stop Press the ‘Start/Stop’ button to start the operation or
to stop the ongoing operation.
7 Pulse and LED Press the ‘Pulse’ button once to start the pulse
operation and press it again to stop the operation.
The Pulse LED will glow to indicate Pulse is activated.
It can also be used for programmable pulse mode.
8 Prog Hold down the ‘Prog.’ button to enter in the program
mode and use the other required buttons to set the
parameters for the selected program.
Powering the device ON
1. Connect the power adaptor to the back of the device
2. Switch the main power supply to ON
3. Switch the device ON from the back
ATTENTION: Ensure that the tubes are loaded correctly before use. DO NOT start the
device if the hinge is open.
Setting the speed
1. Press the ‘Speed’ button to select the speed value
2. Press the ‘Increment/Decrement’ button to set the required speed
The speed for operation ranges from 10 RPM to 80 RPM with incremental or
decremental steps of 1 RPM. The speed values are saved after blinking five times.