Westinghouse WSF6608, User Manual, Page: 24 / 28

24
FAILURE CoDES FAILURE CoDES
fAiLURE codES ANd WHAT To do iN cASE of fAiLURE
pRAcTicAL ANd USEfUL iNfoRMATioN
1 Whenever you will not be operating your machine:
• Unplug the machine and then turn the water off.
• Leave the door slightly ajar in order to prevent the
formation of unpleasant odours.
• Keep the machine interior clean.
2 Eliminating water droplets:
• Wash the dishes with the intensive program.
• Increase the rinse aid setting.
• If plastic items are washed, water drops on these
items will be unavoidable. Programs with higher
temperatures and increased rinse aid settings may
reduce the water drops. Check that the plastic
items are suitable for dishwasher use.
3 Correctly loaded dishes will give the best energy
consumption, washing and drying performance.
4 Clean all rough waste before you place dirty dishes in
the machine.
5 Operate the machine after it is completely full.
6 Use pre-washing program only when necessary.
7 Observe program information and average
consumption values table when selecting a program.
8 Since the machine will reach high temperatures, it
should not be installed near a refrigerator.
9 If the appliance is located in a place where the risk
of freezing exists, you must completely drain the water
that has remained in the machine. Turn off the water
tap, disconnect the water inlet hose from the tap and
allow the interior water to drain.
ERRoR codE ERRoR dEScRipTioN coNTRoL
F5 Inadequate water supply • Make sure the water tap is open and that main water supply is
on.
• Close the water tap, separate the water inlet hose from the tap
and clean the filter at the connection end of the hose.
• Restart your machine, contact the service centre if the error
resumes.
F3 Error of continuous water input • Close the tap.
• Contact the service centre.
F2 The waste water in the machine cannot be
discharged
• Water drain hose is clogged.
• Spigot on sink tap is blocked.
• The filters of your machine might be clogged.
• Power off your machine and activate the program cancellation
command.
• Check the drain spigot’s membrane has been removed or
blocked.
• If the error continues, contact the service centre.
F8 Heater error Contact the service centre.
F1 Alarm is active against water overflow • Power off your machine and close the tap.
• Contact the service centre .
FE Faulty electronic card • Contact the service centre.
F7 Overheating error (temperature in the
machine is too high)
• Contact the service centre.
F9 Flow Control Valve position error • Contact the service centre.
F6 Faulty heater sensor • Contact the service centre.