Westinghouse WHE6200S, User Manual

Page: 6 / 20

INSTALLATION OF WHE6200
Adequate ventilation around your refrigerator.
The diagram below shows the recommended airspace
to allow for ventilation of your refrigerator.
If 5mm side clearance, the fridge cabinet must sit at least
5mm proud of kitchen cabinetry for doors to open.
A 5mm side clearance requires 50mm rear clearance.
If you do not have a cupboard above the refrigerator with
a rear gap of minimum 100 (Y), recommended clearance
at the top of the refrigerator are as follows: If gap (Y) is not
a minimum 100mm, then gap (Z) increases from 50mm to
90mm min. When positioned in a corner area, spacing of
at least 300mm on the sides will allow the doors to open
enough to enable the removal of bins and shelves.
50mm
5m
m
5m
m
CABINET
DOOR DOOR
Minimum
recommended
airspace
(z)
(Rear gap)
(y)
300mm 300mm
NOTE: Doors are designed to sit proud of cabinetry
(not flush). The clearances shown above are the
recommended minimum clearances. The clearance at the
rear must not exceed 75mm.
Installing your refrigerator
Your refrigerator should be levelled using front adjustable
stability feet ensuring it does not rock.
WARNING
CAUTION
The rollers are designed for forward or backward
movement only. They are not castors. Moving the
refrigerator sideways may damage your floor and the
rollers. Before moving the refrigerator, wind up the two
front adjustable stability feet.
stability foot
wound up
1. Roll the refrigerator into place.
2. The top of the refrigerator should be tilted back by
10mm (see diagram on below). This will allow the
doors to self-close providing a consistent door seal.
3. If the refrigerator isn’t tilted back, you can adjust
the two front stability feet (see diagram above). If
you have difficulty turning the stability feet, have
someone tilt the refrigerator back, so you have
better access.
Height adjustable
front rollers
Fixed rear rollers
10 -15mm
6
INSTALLATION