6
Westin Automotive Products, Inc.
320 W. Covina Blvd
San Dimas, Ca. 91773
Thank you for choosing Westin products
for additional installation assistance please call
Customer Service (800) 793-7846
www.westinautomotive.com
P.N.: 75-583110-RevA
ECO #: W18-0083
DATE: 09/11/18
9. Reuse the factory hardware to attach the Support Bracket to the front of the frame. Do not fully tighten.
10. Repeat
Steps 6—9
to install the driver side Frame Bracket assembly.
11. If equipped with factory fog lights, unplug both lights and remove the complete light assemblies from back of bumper,
(Figure 11)
. Unplug and remove the adaptive cruise control, if equipped.
Fig 11
12.
Models with factory fog lights
:
- Use a flat blade screwdriver to carefully pop out the tabs on the side of the fog light bracket attaching the light to the
bracket,
(Figure 11)
. Pop the light out of the plastic bracket housing.
- Remove the adjustment screw and spring from the light assembly.
- Select the passenger top U Bracket,
(Figure 12)
. Attach the Bracket to the slot in the light opening with (1) 8mm x
20mm Hex Bolt, (2) 8mm Flat Washers and (1) 8mm Nylon Lock Nut,
(Figure 12)
.
- Carefully spread the sides of the Bracket enough to slide the OE plastic fog light between and into the Bracket,
(Figure 13)
. Attach (1) Lower U Bracket to the Upper Bracket with (2) 6mm x 16mm Hex Bolts, (2) 6mm Lock
Washers and (2) 6mm Flat Washers,
(Figure 14)
.
- Insert the factory spring between the tab on the Bracket and the light. Insert the screw through the tab, spring and into
the fog light,
(Figure 14)
.
- Repeat to install the driver/left fog light.
Optional OEM fog light installation (light not included).
Attach passenger/right Upper Bracket to the slot in top
of the opening
Fig 12
