3
Westin Automotive Products, Inc.
320 W. Covina Blvd
San Dimas, Ca. 91773
Thank you for choosing Westin products
for additional installation assistance please call
Customer Service (800) 793-7846
www.westinautomotive.com
P.N.: 75-4624025-RevA
ECO #: W19-0076
DATE: 12/12/19
PROCEDURE
1. Remove contents from box, verify if all parts listed are present and free from damage.
Carefully read and understand all instructions before attempting installation.
Failure to identify damage before installation could lead to a rejection of any claim.
2.
Start below the front of the vehicle. Unbolt the two factory bolts (four if tow hooks are equipped) from the bumper bracket
on each side. Remove 2 lower factory bracket bolts to remove it from the vehicle.
See Figure 1 & 2
Note: (Tow hooks can-
not be reused and lower factory bracket cannot be reused.)
Fig. 1
Remove tow hook
bolts if equipped
Remove lower factory
bracket if equipped
Remove bolts to
remove bumper
Remove bolts to
remove bumper
3. Unplug any lights or wiring and remove the bumper.
4.
Once bumper is removed unbolt and pry the center mesh in the bumper.
5.
Proceed to cutting the side pockets.
Note:
(You may try to trim only the necessary area needed for the brackets to poke
through but it will be a much easier installation process if the sides are completely cut off.)
See Figure 3
6.
Reinstall the mesh to the bumper using the previously removed nuts.
CUT
CUT
Fig. 2
Fig. 3