31031 R1
51
•
When cranking in (clockwise) = loud clicking
•
When cranking out (counterclockwise) = no clicking and ratchet pawl fully engaged into gear teeth.
To Replace the Lift Cable:
1. Unwind the winch drum until cable is slack and remove all cable clamps.
2. Free the cable from the winch and pulleys.
3. Remove the cable clamps that secure the hook in place.
4. Reverse the above steps to install the new cable.
7.17. Adjust the Mover Kit Ram and Travel Speed
Æ
When Equipped:
Place the machine on level surface and fully lower the intake and discharge ends. Ensure the
engine is in idle and the auger drive is disengaged before adjusting.
Hydraulic Pressure Adjustment
If the controls are "jerky" or act too fast, it may be necessary to adjust the hydraulic pressure on the wheel
move. To do this, follow the steps below and refer to
Figure 26 on page 51
.
1.
To decrease hydraulic pressure:
Loosen the nut on the three spool valve (bottom right side of valve) and
turn the adjustment screw out (counter-clockwise). Tighten the nut.
2.
To increase hydraulic pressure:
Loosen the nut on the three spool valve (bottom right side of valve) and
turn the adjustment screw in (clockwise). Tighten the nut.
RAM Speed Adjustment
Ram speed in each direction of travel is regulated at the control valve. Adjust the stroke limiter screws and jam
nuts until the desired rate of travel is achieved.
• Turning the screws inward results in a slower speed.
• Turning the screws outward results in a faster speed.
Figure 26.
Control Valve Adjustment
STX2 SERIES – PORTABLE GRAIN AUGER
7. MAINTENANCE
