![background image](http://html1.mh-extra.com/html/westfalia/tornado-80-03-92/tornado-80-03-92_instruction-manual_963592014.webp)
9
Operating
Before first Use
Remove the unit and the accessory out of the packaging. Keep packaging
materials out of reach of children. There is risk of suffocation!
Clean all parts of the unit before using for the first time, as described in the
chapter “Cleaning“.
According to factory-made functional tests, residual humidity can remain in the
pump. Residual humidity in a new article in not a fault.
According to BS EN 1717 it is not permitted to connect a high-pressure
cleaner directly to mains drinking water supply. Short-term connection is
permissible, if a backflow preventer valve is installed in the supply hose.
Respect the requirements of the local water supply company when using high-
pressure cleaners.
The high-pressure cleaner is provided with overheating protection. This
overheating protection protects the motor against overheating and damaging.
If the thermal sensor is activates wait some minutes. Wait until the thermal
sensor has cooled down and switch on the cleaner again.
Assembling
1. Place the high-pressure cleaner on a solid, level ground. Only operate the
high-pressure cleaner in upright position. Fold up the carrying handle (4)
and tighten the locking screw (16) at the rear side of the handle.
2. Mount the lance (7) and the spray gun (14) together by inserting the lance
into the gun opening and turning counter clockwise. The lance and the
spray gun are equipped with a bayonet lock. To remove the lance, press
and turn the lance clockwise and pull out of the spray gun.
3. Connect the water hose with the
coupling for water inlet (8) and with
the water supply in your house.
4. Connect the high pressure hose
(11) with the spray gun. Screw the
other end of the high-pressure
hose firmly on the provided
coupling (9).
Make sure all hose connections are correctly and properly sealed before
operating the high-pressure cleaner. Only hand-tighten the connections
and do not use any tool to avoid damaging the threads of the coupling.