16
Operating
When inserting the battery into the charger, make sure it can be easily
inserted. Do not use force. Please note that the battery and the charger
can warm up slightly bit during charging.
4. When the red charging LED (12) starts flashing, the charging process is
finished. Remove the battery and unplug the power cord from the wall
socket.
5. If the charging LED and the power LED flash alternately, it indicates that
charging process is abnormal resp. the battery is damaged.
Inserting and Removing the Battery
1. Slide the battery (7) into the cordless screw-
driver, as shown in the picture.
2. When inserting the battery, make sure it can
be easily placed. Do not use force.
Slide the battery as far as it will go until the
releasing button (8) audibly locks in.
3. For removing the battery, press the releasing
button and slide the battery out of the screw-
driver.
Turning ON and OFF
1. To turn the unit on, press the ON/OFF trigger (5). To turn off the cordless
screwdriver, release the trigger.
2. The ON/OFF trigger is also used to control the rotation speed. The deeper
the trigger is pressed, the faster the unit runs. When the machine is turned
on, the LED work light (6) shines.
3. By pressing the rotating direction button (4) the rotating direction can be
reversed. In the middle position the ON/OFF trigger is locked. Set the
switch in this position when laying down the machine to avoid accidental
start-up.
4. The rotating direction button can only be pressed, while the ON/OFF
trigger is released.
Inserting Drill or Screw Bits
Please note! Before changing drill bit and screw bit, set the rotating direction
button (4) into the middle position to avoid unintentional start-up.
