13
Operating
Operation
Before cleaning the floor we recommend to test the steam mop on a hidden
place.
First, we recommend vacuuming the floor first and than using the steam mop.
1. On lightly soiled surfaces start cleaning by slowly passing the steam mop
back and forth.
On heavily soiled surfaces press down the steam foot and scrub the dirt by
moving it back and forth. The steam power will efficiently remove the dirt from
the ground.
Do not let the steam mop during operation to stand on any place for long
time. Hot steam and the wet floor cloth could damage the floor (e.g. wood
floor).
2. While cleaning, observe the water level in the water tank (6). If the water is
used up, pull the power plug and refill the water tank. Never operate the
steam mop without water!
Using the Carpet Attachment
1. Attach the carpet attachment to the steam foot. By doing
this the floor cloth cannot slip from the foot.
2. Clean the carpet by moving the steam mop back and
forth.
Short Work Break
When interrupting operation for short time, lift up the steam
mop handle completely, so the ball joint will touch the notch
in the steam foot. In this position steam will be shut off.
Finishing Work
1. Turn the steam control to the position CLOSE.
2. Pull the power plug and carefully remove the floor cloth.
Please note the cloth might be hot!
3. Pour out remaining water from the water tank. Wind up the power cord
around both cord storage hooks (2 and 8).
