12
Operating
2. Connect the 2 pieces tube (4) together
and insert the assembled tube into the
steam mop.
3. Fill in normal temperate tip water or
preferably distilled water into the water
tank. Do not add any chemicals. Do not
fill more than 400 ml water in the tank.
4. Place the water tank on the steam mop
and engage with the locking lever (5).
Start up
1. Place the floor cloth (13) on the ground,
the hook and loop fastener facing
upwards and press down the steam foot
on the cloth. The bottom side of the
steam foot is equipped with hook and
loop fasteners that match the fasteners
on the cloth.
Never use the steam mop without floor
cloth!
2. Unwind the cord completely. Run the
power cord over the cord storage hook (2)
and make sure the cord cannot become
a tripping hazard. Do not pass over the
power cord with the steam foot.
3. Plug the power cord to mains and the indicator lamp (9) with light up.
4. Adjust the amount of steam with the steam control (7). Within 30 seconds the
steam mop will be ready for use. Turn the steam control in direction OPEN for
full steam and in direction CLOSE in order to minimize the amount of steam
or switch off completely.
