Dokument: 1597en06.doc
Förf.: LT/JJo
Datum: 2017-11-30
Sida: 5 av 9
WESTERSTRAND URFABRIK AB
Box 133
Tel. 0506 48 000
Internet:
www.westerstrand.se
545 23 TÖREBODA
Fax. 0506 48 051
E-mail:
Mounting of hands version 115014-00 LMV-UV
1.
Mount the movement to the gear for the hands.
2.
Mount the hand(s) on the shaft with needlepoint(s) aming straight to 12.
3.
Fasten the hour hand(s) carefully.
4. Mount the minute hand(s) on the shaft with needlepoint(s) aiming straight to 12.
IMPORTANT!
There should be some space on the shaft between the minute- and hours hand.
5. Fasten the minute hand(s) carefully.
5. Installation and test.
1.
Connect to 230 VAC via the terminal (8A) and protective earth to terminal (8B). When installed a readily
accessible disconnect device shall be incorporated in the fixed wiring.
2.
Connect the impulse wire from the master clock via the plug inclosed in delivery.
3.
Check that the movement setting remains on full hour, e.g the red arrow (6) points straight to 0-mark.
4.
Connect the plug to the movement at (7).
5.
Switch on the mains.
6.
Wait for a minute impulse for step forward to odd minute.
7.
Now the setting plate (1) should turn one mark anti-clockwise and the hands are moving one minute forward.
- If so, the movement are ready for operation.
- If not, the connection to impulse (7) is wrongly polarized. Adjust as follows:
A. Disconnect mains
B. Tur the connector to impulse around or swap wires in the connector.
C. Check procedure from step 3 above.
