Lit. No. 28270, Rev. 00
July 1, 2005
29
Scoop/Vee Blade Position
Move the control lever from the
center position toward the "SCO" of
SCOOP or the "EE" of VEE on the
face of the control body. The use of
either of these slots will cause both
the left and right wings to move at
Function
Description of Operation
SCOOP
Move the control lever toward the word, SCOOP, on the control face to
extend both wings forward into the scoop position. Function times out
after 5.5 seconds.
VEE
Move the control lever toward the word, VEE, on the control face to retract
both wings into the vee position. Function times out after 5.5 seconds.
Function
Description of Operation
L WING
When the control lever is moved to the left side of
LOWER
, the left wing
will move either in or out. The first time the lever is moved into the slot
after the control is turned on or another function is used, the wing will
extend. Repeated use of lever in the same slot, without using another
function, results in movement in the opposite direction from the previous
movement. Function times out after 5.5 seconds.
R WING
When the control lever is moved to the right side of
LOWER
, the right
wing will move either in or out. The first time the lever is moved into the
slot after the control is turned on or another function is used, the wing will
extend. Repeated use of lever in the same slot, without using another
function, results in movement in the opposite direction from the previous
movement. Function times out after 5.5 seconds.
Function
Description of Operation
RAISE
Move the control lever toward the top of the control body to raise the
snowplow and cancel the float mode. Function times out after 3.0 seconds.
LOWER
Move the control lever toward the bottom of the control body to lower the
snowplow. Release the lever to stop blade at desired height.
FLOAT
Move the control lever to the
LOWER
position and hold 3/4 second to
activate this mode. The
FLOAT
indicator light in the upper right corner
of the control face will illuminate. The blade will lower to the ground
surface and follow the contour of the surface as it dips or raises. Function
does not time out; however, control will shut down after 20 minutes of
nonuse.
Move lever to the
RAISE
position momentarily to cancel float. Angling
left or right will interrupt (stop) the float function while the blade angles,
but will return to float when angling is complete.
L –
Angle
Left
With wings in a straight line, move the control lever straight to the left to
move both wings to the angle left position to cast snow to the driver's left
side. The left wing retracts while the right wing extends. Function times
out after 5.5 seconds.
R –
Angle
Right
With wings in a straight line, move the control lever straight to the right to
move both wings to the angle right position to cast snow to the driver's right
side. The right wing retracts while the left wing extends. Function times out
after 5.5 seconds.
Float
Light
(green)
Control Functions
Raise, Lower, Float, Angle
Movement of the control lever in
straight lines up and down or from side
to side on the control body will result in
the following blade movements:
NOTE: If control function times out
before desired blade movement is
complete, refer to the General
Diagnostic Table in the
Troubleshooting section of this
guide.
the same time into the following
blade positions:
NOTE: Blade wings may not move
at the same speed.
Wing Positions
Move the control lever from the
center position toward the word,
WING, on either side of the face of
the control body. The use of either of
these slots will allow movement of
either wing independently of the
other as described below.
SYSTEM OVERVIEW – CONTROLS