Lit. No. 28270, Rev. 00
July 1, 2005
10
SYSTEM OVERVIEW – BLADE, T-FRAME & LIFT ASSEMBLIES
Config. 1
Config. 2
Config. 3
Config. 4
INITIAL STAND SHOE SETUP
The illustration below shows the
recommended starting positions for
configuring your stand shoes.
9-3/4" to 11-1/4"
1-3/8" to 2-1/8"
Roll Pin
STAND SHOE ADJUSTMENT
1. Attach plow to the vehicle mount.
With plow lowered to the ground
and on level pavement, measure
the dimension from the ground to
the center of the pivot bar cap
screw. This dimension must be
9-3/4" to 11-1/4".
2. With the plow attached and on
the ground, place the stand arm
in the lower position with the lock
pin engaged and with the stand
shoe fully retracted in the "up"
position. Measure the distance
from the ground to the bottom of
the stand shoe. This distance
should be 1-3/8" to 2-1/8". The
stand can be adjusted to achieve
this dimension by removing the
roll pin and selecting the proper
hole in the stand stem. When the
stand height is correct, cut and
remove the spring tie.