4.1.1.
Default Baud Rate (Sw1, Sw2, Sw3)
Setup Switches one through three select the
default
baud rate for
all MDS Ports. The default baud rate must match the rate your
control device will use when communicating with the MDS. If
the control device will communicate via modem, select a default
baud rate that is compatible with the modem.
After the MDS has been installed, the /P command can be used to
select individual baud rates for each port.
SW
Baud Rate
1
2
3
D
D
D
9600*
U
D
D
300
D
U
D
1200
U
U
D
2400
D
D
U
4800
U
D
U
9600
D
U
U
19.2K
U
U
U
38.4K
* = Factory Default
4.1.2.
Default Handshake (Sw4)
The default handshake format should be set to match the device
attached to Port 1. Setup Switch 4 can select either DTR
(hardware) or XON/XOFF handshaking.
After the MDS has been installed, the /P command can be used to
select both DTR
and
XON/XOFF handshaking, or
no
handshaking. The /P command can select a different
handshaking format for each port.
Switch 4
Handshake
Down
DTR *
Up
XON/XOFF
* = Factory Default
4-2
MDS Series Users Guide
Summary of Contents for MDS-16
Page 20: ...4 6 MDS Series User s Guide...
Page 38: ...6 12 MDS Series User s Guide...
