Page
31
of
55
Maintenance and servicing
13
Maintenance and servicing
13.1
General
All maintenance, repair and modification work is to be done on the CM2
XL
only at standstill and when the engine is switched off. The procedure described in
the operating manual for stopping the machine must be strictly adhered to.
The CM2
XL
is to be checked to ensure it is in a safe condition and
secured to prevent it rolling away.
The safety regulations in chapter 4
apply.
Note before starting work:
Check for externally visible damage and defects! Immediately report
any changes (including those regarding operating behaviour) to the
responsible service personnel! If necessary, take the machine out of
service immediately!
Check the completeness and functionality of all accessories. Worn
parts, or those whose functionality has been impaired must be
replaced. Replacement parts must be ordered from the
manufacturer.
Monitor the completeness and legibility of all type and information
labels as well as the operating manual. Replace missing or illegible
signs and documents.
