Westen star master 240 Fi, Instructions For The User And The Installer

Page: 40 / 108

40
925.476.4 - EN INSTRUCTIONS PERTAINING TO THE INSTALLER
15.2 LAS FLUE DUCT INSTALLATION OPTIONS
15.3 VERTICAL FLUE TERMINAL INSTALLATION OPTIONS
This type of installation can be carried out both on a flat or pitched roof by fitting a terminal, an appropriate weathering
tile and sleeve, (supplementary fittings supplied on demand).
For detailed instructions concerning the installation of fittings refer to the technical data accompanying the fittings.
SEPARATED FLUE-AIR DUCTING
This type of ducting allows to disengage exhaust flue gases both outside the building and into single flue ducts. Comburant
air may be drawn in at a different site from where the flue terminal is located.
The splitting kit consists of a flue duct adaptor (100/80) and of an air duct adaptor. For the air duct adaptor fit the screws
and seals previously removed from the cap.
The flue duct must not fall and all horizontal runs must always rise at approximately 3° from the boiler. Consideration for
protection to exposed parts of the outlet duct where accidental touch may occur must be given.
Calculation of the total equivalent length:
The total equivalent length depends on the number and type of components in the flue system.
The total equivalent length is the addition of Air Duct Value + Flue Duct Value, plus the equivalent length of any bends.
The bend equivalences are:
45° = 0.25m
90° = 0.50m
ASSEMBLING THE FLUE SYSTEM
The pipe extensions can be cut to length if necessary. The cut end should be de-burred to prevent damage to seals when
assembling to a fitting.
Apply soap solution to all seals to aid assembly.
Always use 80mm pipe clamps to secure/support the ducts. Secure the roof terminal with the pipe clamp supplied.
L max = 4 m
0512_2002
L max = 4 m
0503_0908 / CG_1641
L max = 2 m
L max = 3 m
L max = 4 m