VHF-UHF Bi-Directional Amplifier Installation and Users Guide
System Operation: 5.4 BDA Alarms Page
WESTELL.COM
1-800-377-8766
Page 5-12
Editing Alarms
Click the
EDIT ALARMS
button to change the
configurations of any alarm. The
ALARM
CONFIGURATION
popup will appear as shown at
right. This popup must be active to edit any of the
alarm configuration settings.
Tip:
Click and drag this and similar popups
anywhere on the screen as needed.
As shown in
below, the user can now configure the
Mask
checkbox and
slide controls to set the
Alarm
Delay
and
Frequency
of SNMP traps sent.
Figure 5-9
Accessing alarm configuration tools
To edit an alarm, follow these steps:
1. Click the
EDIT ALARMS
button to open the
ALARM CONFIGURATION
popup.
2. Double-click on the first alarm you want to edit. Activate the tools to adjust
settings as shown in
3. To mask (disable) the alarm, check the
Mask
checkbox. The alarm will not
activate audible or visual annunciators while masked.
CAUTION:
Permanent alarm silencing via the web interface is not permitted for
installations requiring full compliance to UL 2524.
4. To set a time delay before an alarm is reported, adjust the
Delay
setting to the
desired delay (minutes).
5. To set the frequency with which the alarm will send SNMP traps, adjust the
Freq.
setting (minutes).
1. User double-clicks
2. Indicator expands to reveal Mask checkbox
and Delay and Frequency slide controls
3. User adjusts settings as desired
alarm indicator
