UltraLine II VDSL– Draft 1
030-300237 Rev. A
8/8/06
030-300237 Rev. A
25
August 2006
User Guide
UltraLine II VDSL Gateway (Model 826010)
8.5
Disconnecting Your WAN Connection
If you have finished browsing the Internet and want to disconnect from your Internet service provider, click
Disconnect
in the
Connection
screen.
CAUTION
: If you click
Disconnect
, this will disconnect the Gateway from the Internet, and Internet access for all
users connected to the Gateway will be down until the WAN connection (PPP session) is re-established. The WAN
Connection field will display
Down
; however, your VDSL sync will not be affected, VDSL Line Status will remain
Up
. If you want to end your VDSL session, simply power down the Gateway via the power switch on the Gateway’s
rear panel.
When you are ready to re-establish a WAN connection, click
Connect
and wait a brief moment for the WAN
Connection to display
UP.
If you powered down your Gateway, you must first power up the Gateway, and then log
in to your connection profile to establish a WAN connection, as explained in section 8.4, “Establishing a WAN
Connection.”
NOTE:
When you are ready to exit the Gateway’s interface, click the
X
(close) in the upper-right corner of the
screen. Closing the screen will not affect your PPP Status or your WAN connection. When you are ready to restore
the Gateway’s screen, you must launch your Internet browser and type
http://192.168.1.1/
in the browser’s address
bar, and then press
Enter
on your keyboard.
