Westbrook Trailers 48-048-K08, Assembly Instructions Manual

Page: 22 / 34

22 Assembly instructions for kit trailers
P.
STEP 8 – Wiring & Lights
ITEM # DESCRIPTION 4’ x 4’ 4’ x 6’ 4’ x 8’ 5' x 8'
500512 4 WAY FLAT 20’ WIRE HARNESS 1 1 1 1
503079 8” CABLE TIE 4 6 6 6
500558 WIRE CONNECTOR 2 2 2 2
500513 TAILLIGHT LEFT/DRIVER SIDE 1 1 1 1
500514 TAILLIGHT RIGHT/PASSENGER SIDE 1 1 1 1
500515 AMBER MARKER LIGHT 2 2 2 2
500516 PLASTIC LICENSE BRACKET 1 1 1 1
1. Feed the wire harness using the pre-cut holes all the way to the back and tuck some of the wire in the front
corner for the marker light.
2. Place the amber marker light in the pre-drilled holes and secure it to the frame.
3. With a knife carefully separate the brown and coloured wire near the front corner and marker light.
4. Push the brown wire from the wire harness completely to the back of the wire connector.
5. Slide the marker light wire into the blue connector without exposing any wire.
6. Squeeze the metal blade of the connector down with pliers tight enough to make a connection between
both wires. Verify that the blade is all the way in place and close the cover.
7. At the back of the trailer, cut the wire leaving 6”, then strip 1/4” and twist the copper wire. Do this for both
sides.
8. Plug each wire to the corresponding hole in the back of each taillight, and secure them to the frame.
9. Secure the license plate holder on the driver’s side with the taillight.
10. Pull the excess wire back into the frame and secure it with the zip ties using the holes.
11. Always test the lights before using the trailer.