Westbrook Trailers 48-048-K08, Assembly Instructions Manual

Page: 10 / 34

10 Assembly instructions for kit trailers
P.
Step 1b- Frame Assembly - 4’x 6’ Kit Trailer Frame
ITEM # PARTS DESCRIPTION QTY
501049 3/8 X 3/4 HEX FLANGE BOLT 4
501033 3/8 X 1 1/2 HEX BOLT (FULL THREAD) 8
501031 3/8 FLANGE LOCK NUT 12
500254 FRONT CHANNEL 1
500255 CROSS CHANNEL 1
500256 REAR CHANNEL 1
500252 6’ DRIVER SIDE CHANNEL 1
500298 6’ PASSENGER SIDE CHANNEL 1
IMPORTANT INFORMATION
• You will be assembling
the trailer upside down
to avoid having to flip it twice during the asembling
process.
• Gather the frame pieces and the hardware placing them in their respective position as shown in Figure
When placing your frame piece, match the hole configuration shown in figure 1. For example the
passenger side channel the square holes should be facing up .
• The longer hex bolts will be used to secure the plywood floor with frame.
ASSEMBLY INSTRUCTION
1. Both passenger and driver side channel overlaps with the front channel; do not insert one inside the other.
(see Figure #1). Loosely connect the channel using the 3/8 x 3/4 hex flange bolt and 3/8 lock nut on the top,
and the 3/8 x 1 1/2 hex bolt and 3/8 lock nut at the bottom.
2. Take a cross-channel and install a grommet on each hole, then loosely connect both to the frame using the
3/8 x 1-1/2 hex bolt and 3/8 lock nut at the bottom only . The top will be secured when you install the axle.
3. Repeat for other side.
4. Slide the rear channel over the passenger and driver’s side channel and loosely connect using the 3/8 x 3/4
flange bolts and 3/8 lock nuts on top, and the 3/8 x 1-1/2 hex bolts and 3/8 lock nuts at the bottom.
Assemble the frame but only hand-tighten the hardware, they will be tightened in a later step.